{"id":509,"date":"2011-10-16T18:00:44","date_gmt":"2011-10-16T23:00:44","guid":{"rendered":"http:\/\/devinjpoore.com\/?p=509"},"modified":"2011-10-16T18:00:44","modified_gmt":"2011-10-16T23:00:44","slug":"viper-cockpit-again","status":"publish","type":"post","link":"https:\/\/devinjpoore.com\/?p=509","title":{"rendered":"Viper: Cockpit, Again."},"content":{"rendered":"

\"\"I’m reasonably sure that the fuselage is now ready for final primer and paint.\u00c2\u00a0 That means that I have to get the canopy on and smoothed into the fuselage (it has gaps, of course), and to do that our pilot has to go in first.\u00c2\u00a0 The kit instructions say if using the pilot, you are to cut off the top of the control stick and glue that to the bottom of the control stick already molded into the pilot’s hand.\u00c2\u00a0 As you can see from the first photo, they don’t even come close to meeting up.\u00c2\u00a0 Had I known of this issue before putting the cockpit into the fuselage, I would have built up the center console so that it looked right, but at this stage all I could do was drill out the base of the stick and put in a piece of wire to make up the difference.<\/p>\n

The pilot didn’t quite want to fit.\u00c2\u00a0 Wide hips, narrow seat.\u00c2\u00a0 With a little pressure, though, it worked.\u00c2\u00a0\u00c2\u00a0 I broke out the super glue, a bar clamp, and repeated over and over as I tightened the clamp “please don’t snap his neck, please don’t snap his neck…”<\/p>\n

The final piece is a custom tool I made for the build.\u00c2\u00a0 1mm square styrene stock with strips of 200 grit sandpaper glued to it.\u00c2\u00a0 For the small recesses at the top of the engines and around the seat of the thrusters, this is all that would fit in there.<\/p>\n

Next up: put on the canopy and start masking for primer and paint.<\/p>\n\r\n\t\t